From basic air quality screening to forensic-level fungal investigation — the right test for your situation.
💨
Non-Viable Spore Trap Air Sampling
The workhorse of mold air testing. Spore traps collect non-viable particles — both live and dead spores — giving total spore counts by genus. Standard for most Elmwood Park residential and commercial testing scenarios.
🏭
Viable Culture Air Sampling
Culture plates capture live, culturable mold spores that then grow in the lab — allowing species-level identification and colony-forming unit counts. Used when species-level data matters: occupational health concerns, Stachybotrys investigation, or situations where genus-level data from spore traps isn't sufficient for your Elmwood Park, IL use case.
🎖
Surface Swab & Tape Lift Sampling
Surface samples collected from visible growth areas — swabs for culture analysis or tape lifts for direct microscopy — identify the species present on specific surfaces. Used to confirm whether visible staining is mold and which genus/species is involved before committing to remediation scope.
📄
Post-Remediation Clearance Testing
After mold remediation, clearance testing compares treated zone air samples to outdoor baseline — confirming indoor spore counts are back to acceptable levels before re-occupancy. Our Elmwood Park, IL clearance testing uses the same accredited lab protocol as pre-remediation sampling, so results are directly comparable.
🏢
HVAC & Ductwork Air Testing
Testing at HVAC registers and returns identifies whether the air distribution system is a mold source. High spore counts at registers compared to room-level samples indicate the system is contributing to indoor air quality problems — a critical finding before any duct cleaning or coil remediation decision in Elmwood Park.
🔋
Bulk & ERMI Sampling
ERMI dust sampling for your Elmwood Park property gives a historical picture of mold accumulation — useful when symptoms are present but air sampling comes back normal, or when assessing long-term remediation success.
